Процедура обновления прошивки
After updating the firmware, you need to restore the factory settings and reset all parameters through the display.
После обновления (лучше и до) необходимо сбросить параметры на заводские и задать параметры через экран.
- The internal storage space is re-planned. After updating the firmware, you must restore the factory settings and reset and level them.
- Rewrite the material detection filter algorithm to reduce the false alarm rate of material detection (currently in the test version)
- Increase the mileage statistics of each axis, which can be viewed in the system information (currently in the test version)
- Change the high-level duration of the pulse signal of each axis from the original fixed 3us to a dynamic change with the pulse frequency, so as to be better compatible with more drives
- Reduce the pulse upper limit frequency of each axis, from the original 180Khz to 150Khz (mainly a compromise made to be compatible with the dynamic adjustment of the pulse time)
- Add the function of automatically raising the Z axis after exiting the leveling interface to prevent the possibility of directly heating the print head after leveling and causing the printing platform to be scalded
- Add the homing icon indication function on the main interface
- Optimize the tool setting accuracy during pause and unexpected power failure, after saving the printing progress, when continuing to print
- Added support for M73 command to display remaining time (for prusaslicer slicing software)
- Fix the bug that the temperature is reset to zero when resuming printing after the temperature error is paused
- Repair the recovery error bug that occurs when the refueling action is not completed and clicks to continue printing when the refueling is suspended
- Fix some display errors
